This is a type with a number plate support attached to the engraved LED tail.
Creates a simple rear area.
Since the number plate is attached, a square bar is firmly inserted on the back side to add strength.
The angle is calculated so that the tire does not hit the number plate support even if the body is fully submerged.
The number plate angle is about 45 degrees.
For more information, please also read the blog below.
With LED number plate light.
The tube color is smoked.
<Accessories> Number plate support x 1, LED resistor, button cap bolt (M6 x 15) x 2, washer (M6 x 13 x 1.0) x 2, washer (M6 x 16 x 1.5) x 2, S washer (M6) x 2, nut (M6) x 2
Compatible models: FXSB (Breakout Standard), FXSBSE (Breakout CVO), FXSE (Pro Street)
*The installation image is for illustrative purposes only. Please note that the color may differ from the actual product.
[Blog explanation of the above product. Please take a look. 】
http://trijya.com/blog/?p=3057...
http://trijya.com/blog/?p=2634...
[Points to note when changing tail lamps]
- Light source is 15W or more (tail lamps are 5W or more) and the size of the lighting part is 15 square centimeters or more
- Symmetrical with respect to the center of the vehicle (tail lamps are symmetrical with respect to the center of the vehicle and are inside the turn signal)
- Lighting can be seen from 100m behind during the day (tail lamps can be seen from 300m behind at night)
- Lens light color is red (common)
- Vertical position is 2m or less from the ground to the center of the lamp (common)
- Projected area of the lighting part is 20 square centimeters or more (common)
- Structure with 5 times more luminous intensity when only the tail lamp is on
As opinions on vehicle inspections may differ depending on the Land Transport Bureau in charge,
we do not clearly state.
For details, please check the safety standards for road transport vehicles set by the Ministry of Land, Infrastructure, Transport and Tourism.
http://www.mlit.go.jp/jidosha/...
※Notes※
1. Assembly requires specialized knowledge and skills. We recommend that you ask a specialist store to do the work.
2. You may need to refer to the service manual when installing.
3. Do not start the engine or drive until the work is completely completed.
4. Bolts may become loose due to vehicle vibrations, so check that the bolts are tight before riding.
Please note that we cannot be held responsible for any damage or accidents that may occur if you install the product yourself.