*This product is a handlebar only.
*The dimple specifications have been changed. (See image.)
Width: 760mm
Pullback: Approximately 14cm
- Wiring is routed through the handlebars.
- Chrome-plated finish.
- The riser mounting diameter is 1-1/4".
- The handlebar diameter is the same as the OEM.
Compatible Models: Please see the "Compatibility" tab.
Confirmed to be compatible with the 2023 Breakout (see below).
Compatible with FXBR, FXBRS, FXSB, FXSBSE, and FXSE Breakout
*Can be installed with either an electronic or wired throttle.
[For installation on 2018-2023 FXBR Breakout]
OEM turn signals, brake hoses, and clutch cables can be used. No wiring extensions are required.
Use in conjunction with the "30mm Up Riser Collar" for an even more comfortable position.
・When used in conjunction with the 30mm UP riser collars, there is no need to replace or extend cables.
(Note 1: If not using riser collars, cables may interfere with the tank depending on the installation angle.)
(Note 2: Using riser collars in conjunction with them will reduce excess cable slack.)
・When used in conjunction with the 60mm UP riser collars, there is no need to replace cables, but
you can simply change the clutch cable routing to run between the tank and the triple riser.
Extension of the cables is not necessary, but since there will be some tension, it is necessary to route the cable through the shortest possible distance to avoid interference with other cables.
Extending the cables by about 10cm is best.
When used in conjunction with the Flat Riser Kit
・Breakout models up to 2022: There is no need to replace or extend cables.
The brake hose will fit properly if routed through the triple riser's wiring hole. The clutch cable will have a little extra length.
We offer a complete set of flat riser cables (sold separately) that are best routed like the OEM handlebars, so please feel free to purchase them.
・2023 Breakout: The tank will interfere with the switch box.
[When installing on an FXSB Standard]
Using it in conjunction with the "30mm Up Riser Collars" will provide an even more comfortable position.
There is no need to replace the cables when using riser collars.
(Note 1: If not using riser collars, the cables may interfere with the tank depending on the installation angle.)
(Note 2: Using it in conjunction with riser collars will reduce excess cable slack.)
Black / Polish
Riser 20up Black
Riser 20up Polish
[When installing on an FXSBSE CVO]
If you replace only the handlebars, they will interfere with the tank, so you will need to replace the 52mm Up riser collars and cables.
The following "set" is also available. (Riser colors: Black and Polished)
Sold as a set
Please Note:
[There may be individual differences in the finish of the paint and plating.
If the grips are difficult to insert, modify the handlebars before installation.]
(Inspection is based on the size of the OEM grips.)
Installation images are for illustrative purposes only. Please note that the actual product may differ in color and other details.
Notes:
1. Assembly requires specialized knowledge and skill. We recommend having a professional install the product.
2. You may need to refer to the service manual for assembly.
3. Do not start the engine or drive the vehicle until the installation is complete.
4. Vehicle vibrations may cause the bolts to loosen, so please check the tightness of the bolts before riding.
Please note that we assume no responsibility for any damage or accidents that occur as a result of installing the product yourself.
